You are here:

Classic/Antique Car Repair/1958 Chevy 235 engine

Advertisement


Question
I would like to know the clearance specifications between the rocker arm and the rocker arm shaft.

Answer
I am not sure that I have ever seen in print a specification for this. But the number that I have used over the years would be the same for the rod bearings for this engine, or .001 to .0015". The rockers on the 235 engine is pressure fed and excessive clearance will allow excessive oil leak by and reduce oil pressure.  

Classic/Antique Car Repair

All Answers


Answers by Expert:


Ask Experts

Volunteer


Brad Sears

Expertise

All automotive including antique and collectible. However if the car has been modified I can only answer in general terms and maybe get you pointed in the right direction.

Experience

Automotive tech instructor. Syndicated auto columnist 1970's though the early 1990's. Syndicated auto radio talk show, Ask Brad About cars, CBS Radio 70's through 90's TV Show "Last Chance Garage" 1980's PBS-TV syndicated. Auto instructor for the following companies: Fram Autolyte Holly Carter AMF Ford Motor University Of Conn Blue Hills Technical School Sugar River Technical Center Grew up in a family garage in Needham Mass and turned wrenches from the age of 14.

Publications
Manchester Union Leader, Nashua Telegraph, Motor Service Magazine, Yankee Magazine, Popular Mechanics (Saturday Mechanic early 80's), Los Angeles Times, New York Times, and lots more.

Education/Credentials
More than I care to remember. Basically Franklin Technical Institute in Boston, Northeastern University, Fitchburg State Teachers College, Tufts University, and a lot of factory schools along the way.

Awards and Honors
Moto Award winner. And much more.

©2016 About.com. All rights reserved.