You are here:

Classic/Antique Car Repair/Questions Answered by Expert Jeff Wayco

SubjectDate Asked
gas tank sending unit9/21/2011
  Q: I have a 1931 ford model a vicky. It was built in 1982 and i don't know what tank i have, only that ...
  A: I think you may have accidentally selected the wrong category for the question you are asking...but ...
Replacing A Steering Wheel8/27/2011
  Q: I have a 1987 Jaguar XJ6 and have seen some really nice steering wheels on newer models that I would ...
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” - ...
jaguar 3.8 S won't start7/21/2011
  Q: 8 s that won't start ran fine a few months ago started a few days ago but had TO USE STARTING FLUID ...
  A: I think you may have accidentally selected the wrong category...so at the bottom of my response, I ...
1969 buick skylark7/15/2011
  Q: I have a 100% factory perfct 1969 buick skylark custom. I have not been able to find the location of ...
  A: I think you may have accidentally selected the wrong category...so at the bottom of my response, I ...
Motor size6/26/2011
  Q: 1964 Chevrolet impala block number 852870
  A: I think you may have accidentally selected the wrong category...so at the bottom of my response, I ...
1982 380SL Mercedes6/9/2011
  Q: How do I find a wiring diagram for the fuel pump on this auto?
  A: Good Morning Nancy, I have volunteered to answer questions that relate to “Automotive Wooden ...
1985 JAGUAR XJ65/17/2011
  Q: HAVING TROUBLE LOCATING A NEW BONNET INSULATION PAD. THIS IS A TWO (2) PIECE PAD THAT GOES UNDERSIDE ...
  A: We don't sell those, as we specialize in restoring automotive woodwork and we are Jaguar Cars' ...
Harmonic Balancer install12/30/2010
  Q: I have a 1953 235 motor and I need to install the harmonic balancer. I have greased both the shaft ...
  A: I think you may have accidentally selected the wrong category...so at the bottom of my response, I ...
1967 Bentley T1 door panel11/6/2010
  Q: I hope you're well? I have a 1967 Bentley T1 which the rear drivers side door won't open on. Can ...
  A: Greetings from "across the pond" !! For starters, I would think that there ought to be a fair ...
dash light rheostat10/26/2010
  Q: I know how to remove the dash panel, but is the rheostat screwed on or just pry it out?
  A: You did not mention what year, make or model of vehicle you have. So it would be difficult for ...
1925 Nash wood work10/18/2010
  Q: I just bought a 1925 special six model Nash and the interior wood framing is all bad. I have been ...
  A: ...and although, we restore automotive woodwork...our specialty is restoring the woodwork that ...
motor oil leak10/16/2010
  Q: My dad has a 71 chevy c 10 it has a motor from a 1958 chevy its a283 4.6 it is leaking oil down the ...
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” - ...
secret vin location of jeep grand cherokee9/22/2010
  Q: I need to know if there is any secret vin location for jeep grand cherokee 2004, specially the tow ...
  A: You might want to check with your local Jeep Parts department...they might know. Also, some repair ...
Jaguar9/13/2010
  Q: I need someone from Ohio to fix on my xk150 1959 Jaguar
  A: ...and congratulations on being the owner of that Jag !!! We restore the woodwork in all cars ...
Transmission fluid8/9/2010
  Q: Can I use ATF+4 transmission fluid when chaging the fluid in my 1975 Winnebago "Indian" Motor Home ...
  A: I would suggest that you consult with your local Dodge Dealer - or an reputable transmission ...
1965 horn wiring6/30/2010
  Q: I am installing a woodgrain (STW6KK) 1965-66 deluxe steering wheel. I do not see where the wires ...
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” and I do ...
What kind of Plymouth is this?6/24/2010
  Q: I'm not sure if it is an Plymouth Satellite or Roadrunner. It might be 1973 or 1974. Any help is ...
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” and I do ...
1969 lincoln mark 34/19/2010
  Q: I want to change the exhuast from header back what would be the best one for this car and moter ?
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” and I do ...
suspension question on 57 chevy4/17/2010
  Q: what could cause for the left rear side (driver side) of my car to become lower than the right side. ...
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” and I do ...
Water on floor?3/23/2010
  Q: I own a 1983 MB 380SL and have water on the floor and trunk area after it rains.. Is there a ...
  A: I am going to answer your question in 2 parts. In this First part, I must state that I have ...
1974 F350 One Ton Classic Chargeing Schematics3/6/2010
  Q: "My battery keeps going down as I drive the truck.I have changed the alternator the voltage ...
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” and I do ...
1976 tr6 triumph rear pinion seal replacemeet2/19/2010
  Q: I would like know if some one can tell me how to replace the rear pinion seal on a 1976 tr6 and if i ...
  A: Good Morning Larry, I have volunteered to answer questions that relate to “Automotive Wooden ...
1931 buick2/13/2010
  Q: I have a 1931 buick 8-66-s what makes that call rare.
  A: Good Morning Kevin, Well for starters, it is a very beautiful car, and made in America and I would ...
oil pan gasket2/11/2010
  Q: 64 ford f100 292 auto. trans. what are the steps to change the oil pan gasket?
  A: I have volunteered to answer questions that relate to “Automotive Wooden Interior Trim” - ...
Nash Metropolitan Clutch Master Cylinder2/1/2010
  Q: I have a 1959 Metropolitan convertible. When I went to check the fluid in the clutch master ...
  A: YES, you MUST replace it. Do NOT drive the car until you do, as this is an unsafe condition. Also, ...
monte carlo11/24/2009
  Q: in mid or late 70 a Monte Carlo with rolls roice frontend on it was built i saw a number of them ...
  A: Although your question is way outside my area of expertise, I decided - just for fun - to do a ...
1987 corvette heater11/4/2009
  Q: 1987 corvette heater will not blow hot air controls are in HEAT & HOT position but no hot air comes ...
  A: Good Morning Eric, I do appreciate you asking me a question, however that is NOT in my area ...
'69 Cadillac DeVille Convertible Suspension10/26/2009
  Q: I have an upper control arm busing that needs replacing. While it is apart is there anything else I ...
  A: Good Morning Stephen, I do appreciate you asking me a question, however that is NOT in my area ...
convertible10/21/2009
  Q: can you open a trunk on a 1964 lincoln continental without power
  A: I do appreciate you asking me a question, however that is NOT in my area expertise. I have ...
eletical problems10/20/2009
  Q: hey jeff i hope u can help me out with this but i have a 83 camaro with a 350ci carb and 6 months ...
  A: Well Edward, As I mentioned, your question was outside my area of expertise...but I gave you my ...
eletical problems10/19/2009
  Q: hey jeff i hope u can help me out with this but i have a 83 camaro with a 350ci carb and 6 months ...
  A: For starters I am really happy for you, that you treated yourself to a nice birthday present!! But ...
20/25hp rolls engine9/30/2009
  Q: I am looking for the torque specs for a 1929 20/25hp rolls engine in a ghost,Thank You,Mark Wyatt
  A: I do appreciate you asking me a question, however that is NOT in my area expertise. Hello Mark, I ...
cough or mis when going up a hill or load9/29/2009
  Q: I have a 68 Buick GS 350 I bought the car and decided to replace these items to know the history of ...
  A: I do appreciate you asking me a question, however that is NOT in my area expertise. I have ...
ignition lock assembly removal/replacement9/27/2009
  Q: I have a 1973 Jaguar XJ6, and there is a problem with the ignition lock assembly, do you know the ...
  A: Good Morning William, Yup, you are correct that the "do it yourself" method, can be more involved ...
1989 jaguar XJ69/24/2009
  Q: Last May you answered a question (see below)regarding the refinishing the center console ( ski ...
  A: I was not able to see the "see below" Answer....that you said I gave last May....and I don't think I ...
ignition lock assembly removal/replacement9/7/2009
  Q: I have a 1973 Jaguar XJ6, and there is a problem with the ignition lock assembly, do you know the ...
  A: I do appreciate you asking me a question, however that is NOT in my area expertise. (but further ...
1989 jaguar xj65/17/2009
  Q: im having problems removing the wood in the ski slope console on my 1989 xj6! it seems to be glued ...
  A: YES, you are correct. The construction of that console is a 3 part "sandwich" if you will. And ...
1979 M-B 450SL VALVE LASH4/14/2009
  Q: Need the specification for the valve lash Thanx
  A: I am sorry that I cannot answer your question as it is out of my area of expertise. My area of ...

All Questions in This Category

Classic/Antique Car Repair

All Answers


Answers by Expert:


Ask Experts

Volunteer


Jeff Wayco

Top Expert on this page

Expertise

I can answer general and specific questions that relate to problems with and the repair solutions for, the O.E.M. wooden interior trim found in many marques: Jaguar, Roll-Royce, Mercedes-Benz, Bentley, BMW, Austin Healey, Jensen Healey, Triumph, Lotus etc. etc.

Experience

I have co-owned a company called Madera Concepts since founding it in 1982. We specialize in the repair, refinishing and re-veneering of automotive woodwork, from pre-War to date. If the vehicle came from the factory with wooden interior trim, we have seen and restored it.

Organizations
Rolls-Royce/Bentley Owners Club

Education/Credentials
BA Industrial Education, Major-Woodworking

Past/Present Clients
All Rolls, Bentley, Jaguar and most Mercedes-Benz Dealerships in the U.S. and Canada. As well as thousands of independent automotive repair shops

©2012 About.com, a part of The New York Times Company. All rights reserved.