Expert: Eileen Cronk - 1/17/2010

Question
I have a Lane Furniture end table the style number is 914-05. It has had some normal wear ans tear damage to the top of the piece. It looks like something hot was set on it.  I would like to sand it down and re varnish it in a cherry color.  I am wondering if there is anything I should be aware of before I begin.  And also I know you don't do appraisals but I was wondering if this a mass produced item, and is it worth keeping once I no longer want it.

Answer
Hi Taylor
Nice to hear from you.
I am sending you the refinishing info.

INSTRUCTIONS FOR STRIPPING FURNITURE
The first thing you must do is assemble the material to do the job.
The stripper is the most important item.  
I am hoping you can get "CIRCA 1850" brand paint and varnish remover in your area.
Here is a link
http://www.jamestowndistributors.com/userportal/show_product.do?pid=1694&familyN...

MATERIAL LIST For the stripping stage.
1 gallon stripper
3 boxes of Bull Dog steel wool in medium grade.
One 3 inch oil based paint brush.
Rubber gloves (like you do dishes with), and a pair of cotton gloves inside the rubber ones.
People react differently to stripper. A lot of people feel heat through the rubber gloves, but I feel cold. Have no idea why.
An empty large coffee can. (for the stripper)
A couple of old tooth brushes.
Lots of old rags (I like t-shirts or cotton but for this first stage whatever you have)
Lots of newspaper to protect the garage floor
LOTS OF VENTILATION..A MUST
That's all you need to get started.
HERES WHAT YOU DO...
Work in sections.
Brush on the stripper with the brush. Stripper will quit working if it dries, so keep it wet till the finish softens.
Then take a rag and wipe this mess off.
Then another coat of stripper, rag off again, then while the wood is still wet, take the steel wool and rub with the grain till the wood is nice and clean.
Depending on the material you are removing, another coat of stripper is often needed but you will know this as you progress into the job.
Use the toothbrush in crevices.
Thats all there is to it ...move to another section and continue.
No other prep is necessary...and DO NOT SAND (unless there is wood damage which it appears your table top has).
When the stripping is complete, stain with Minwax stain applied with a rag, then 3 or 4 coats of low lustre tung oil also applied with a rag.
Please let me know if anything is not 100% clear.
Yes your table is factory made and mass produced.
Good luck with your project
Eileen