AboutKevin Expertise I work at a Chrysler,Dodge,Jeep Dealer,
Master AC
Master Drive ability
Master Electrical
Master Brakes
Chrysler,Dodge,Jeep Tech for 13 Plus years
Questions 96 and up only. Please don't ask about a noise,a fluid leak or how much something is to fix thanks.
I do work on the side in the ATLANTA area Email me with Work requests for side jobs kkeller608@aol.com Web page http://home.comcast.net/~kkeller608/
Ignite Home site serving Georgia and Texas please visit http://kevinkellerenergy.mystreamenergy.biz
Experience I work at a Chrysler,Dodge,Jeep Dealer,
Master AC
Master Driveability
Master Electrical
Master Brakes
Chrysler,Dodge,Jeep Tech for 11 Plus years
Education/Credentials 2 year associates degree for Chrysler CAP
Question How do you install the multi-function turn signal switch on a 2006 dodge ram 1500?
Answer Remove the screw (2) that secures the tilt steering column knob (1) and remove it from the tilt actuator (3) on the left side of the column.
3. From below the steering column, remove the two outboard screws that secure the upper column shroud (1) to the lower shroud (3).
4. Using hand pressure, press inward on both sides of the upper shroud above the parting line of the lower shroud to release the snap features that secure the two shroud halves to each other.
5. Remove the upper shroud from the lower shroud and the steering column.
6. Remove the one center screw that secures the lower shroud to the steering column (4).
7. Remove the lower shroud from the steering column.
8. Disconnect the wire harness connector (2) from the back of the multi-function switch housing (1).
9. Rotate the steering wheel far enough to access and remove the two screws (4) that secure the switch to the multi-function switch mounting housing (3).
10. Grasp the switch control stalk and pull it toward the left side of the vehicle to remove the switch from the mounting housing
