AboutKevin Expertise I work at a Chrysler,Dodge,Jeep Dealer,
Master AC
Master Drive ability
Master Electrical
Master Brakes
Chrysler,Dodge,Jeep Tech for 13 Plus years
Questions 96 and up only. Please don't ask about a noise,a fluid leak or how much something is to fix thanks.
I do work on the side in the ATLANTA area Email me with Work requests for side jobs kkeller608@aol.com Web page http://home.comcast.net/~kkeller608/
Ignite Home site serving Georgia and Texas please visit http://kevinkellerenergy.mystreamenergy.biz
Experience I work at a Chrysler,Dodge,Jeep Dealer,
Master AC
Master Driveability
Master Electrical
Master Brakes
Chrysler,Dodge,Jeep Tech for 11 Plus years
Education/Credentials 2 year associates degree for Chrysler CAP
Question QUESTION: How do you remove the Heater Core Holding Box? I can not locate a manual that gives the correct instructions. I know it is located behind the glove box on the passenger side, all manuals I have found do not include 00 Grand Caravan.
Thank you in advance for your assistance.
ANSWER: if u know its behind the glove box then where did u get that info from?
its on the driver side next to the gas pedal.
---------- FOLLOW-UP ----------
QUESTION: that's what i was told by a small-town mechanic, guess he wasn't correct or just didn't care.
I'm trying to do it myself, but can't find any direction son the how to Can you provide me the right directions?
Thank you again for your help.
Answer HEATER CORE
REMOVAL
Drain coolant system.
Remove left side lower column cover.
Remove steering column assembly. Refer to Group 19, Steering for service procedure.
Remove I/P to body harness interconnect and bracket Interconnect And Bracket
Remove lower silencer boot at base of steering shaft Lower Silencer Boot
Pinch off heater lines under the hood.
Remove heater core cover. Insert a small amount of towels under the heater core tubes. Remove heater core plate and tubes Heater Core Plate And Tubes
Depress heater core retaining clips Depress Clips
Pull up on accelerator pedal and slide heater core past Accelerator Pedal
Depress brake pedal Brake Pedal and remove heater core from HVAC housing.
INSTALLATION
For installation, reverse the above procedures. Install screws to retain heater core in housing. Replace heater core tube inlet O-rings. Tighten heater core tube retaining plate to 3 ± 1 N·m (27 ± 9 in. lbs.) torque.
