Aboutcleggsan Expertise All technical areas of Electronics Engineering.
Experience BSEE, MBA, Design, R&D, University Research.
Senior Life Member of IEEE. Life Fellow of AES.
Organizations IEEE, Consumer Electronics Society, Audio Engineering Society.
Broad teaching experience; work experience mostly in consumer electronics and conversion from analog to digital technologies. Pioneer in digital audio at all levels.
Question Hi, I wanted to know if you take an acyclic generator homopolar generator (faraday disk high current low voltage generator) and put it in series with a high voltage source, will the current of both the high voltage source and the acyclic generator add together with a resulting average voltage from the two? In this way you could maybe eliminate the high current brush contacts of the acyclic generator. Is this feasible or am I barking up the wrong tree? I'm just not sure how this can be calculated. Thanks
Answer Nice discussion on the Faraday disc generator at:
ANSWER: If generators or connected in series the voltage adds and the current remains the same through the chain.
If the generators are put in parallel the currents will add, theoretically, but the different voltages will not support a direct connection and the differential of the two voltages will cause a fault of some kind; overheating or burning out of the windings, etc. Even high voltage flash over.
BUT: It may not be a practical solution because of common grounding or common wiring, etc. I am not sure how you would connect them in series. In parallel I think you would be asking for big sparks flying.
