You are here:

Ford/Questions

SubjectDate AskedExpert
2003 Ford Ranger Manual Transmission5/4/2007James Melnyk
  Q: I took my truck for the 60000 mile Maintenance service at a dealer. As part of it they were supposed ...
  A: Yes Joe it is best to drain out all the old mercon v out of your transmission. I also recommend some ...
2001 Ford Focus trouble code P11315/4/2007James Melnyk
  Q: The check engine light goes off within 20 miles because of that code - P1131. It is a 2.0L DOHC ...
  A: sorry for the long delay i had to do some digging with your question. but i do have some places for ...
1994 Ranger front axel knock/click5/3/2007James Melnyk
  Q: Whenever i'm driving, there is a knocking/clicking sound coming from the front pumpkin/driveshaft ...
  A: check to see if there is also any up and down movement at the pinion. that is the flange that is on ...
F150 blower stays on5/3/2007James Melnyk
  Q: My '98 F150 the blower will keep running if not turned off when you shut the truck off and remove ...
  A: wow i think we have the wire for the key in sense misadjusted somewhere Dave. Double check your ...
2003 Ford Ranger Manual Transmission5/3/2007James Melnyk
  Q: I took my truck for the 60000 mile Maintenance service at a dealer. As part of it they were ...
  A: Good day Joe, Thanks for the question. well to start off at all for dealers they are phasing out ...
1994 Ranger front axel knock/click5/3/2007James Melnyk
  Q: Whenever i'm driving, there is a knocking/clicking sound coming from the front pumpkin/driveshaft ...
  A: Hey there Dustin, with the vehicle running try and rotate the driveshaft there really should be no ...
1994 Ranger front axel knock/click5/2/2007James Melnyk
  Q: Whenever i'm driving, there is a knocking/clicking sound coming from the front pumpkin/driveshaft ...
  A: Dustin, Hi there... Are you hearing the noise at the axle or at the transfer case when you are ...
egr ports5/2/2007James Melnyk
  Q: I have a 1998 f-150 thecheck engine light came on a while ago and the truck misses upon ...
  A: Well i hope i can be of assistance. Now by the EGR position sensor I think I am going to have to say ...
82 Ford Mustang Gt 302HO 4 speed...5/2/2007James Melnyk
  Q: I just wondered if you had an idea about what I am experiencing. There seems to be a vibration down ...
  A: It can very well make a vibration because of that. is it an automatic or a manual? If it is a manual ...
Ford F150 1991 5.05/2/2007James Melnyk
  Q: I have high resistance in the wire (that activates the solenoid) running to the starter solenoid ...
  A: Please do a follow up and i will answer as soon as i can. Jim P.s. Sorry for the late reply I was ...
f-1505/2/2007James Melnyk
  Q: replacing lower ball joints on 2wd
  A: I would like to know the year of your truck please. depending on the year either you need to replace ...
1985 F-250 4.9 liter starting/Ignition5/2/2007James Melnyk
  Q: I just purchased a 1985 F-250 with a 4.9 liter motor(replaced with similar), which has the same ...
  A: I have seen this many times with that body style of truck the ignition switch tends to sometimes ...
2002 Ford Windstar5/2/2007James Melnyk
  Q: My trunk will not open using the remote or using the key. What is the problem?
  A: By open i hope you are meaning unlock?? if it is not unlocking can you hear it trying to unlock?? ...
1885 F 2505/2/2007James Melnyk
  Q: My brake lignts don't work and drivers side turn signal won't blink. When I turn on my headlights ...
  A: Brake lights inoperative. if none of the lights work and the fuse is okay in the fuse box you may ...
1989 F250 Oil leak into cylinders5/2/2007Jason Short
  Q: My 460 7.5L is leaking oil fouling the spark plugs, almost a quart per tank with nothing on the ...
  A: Kurt, the first thing you have to do is determine where the leak is coming from. Valve seals are a ...
P1131 Error on '96 Ranger5/1/2007James Melnyk
  Q: I recently got this code after checking the engine light and from what I've read it seems like a ...
  A: Ross, is this a 4 cylinder engine? It is quite hard to back probe an O2 sensor to see what the ...
HISSING NOISE IN AC5/1/2007James Melnyk
  Q: I HAVE A 2005 FORD EXPEDITION EDDIE BAUER. I'M EXPERICING A HISSING/LEAKING/PRESSURE RELEASING SOUND ...
  A: Hmmm, Hi there Mellisa sorry to hear of your little nuisance. I think your dealership was on the ...
ford f-150 overdrive switch5/1/2007James Melnyk
  Q: I have a 2002 f-150 w/ 4.6L V-8. When I hit the switch on the end of the shifter to turn the ...
  A: I think id have to say that there are shorted wires in either the steering column or going to the ...
engine surging5/1/2007James Melnyk
  Q: I have a 1993 Ford Taurus 3.0L V-6, automatic. Just recently the engine has started surging while ...
  A: the rolling or hunting idle could be your IAC Idle Air Controller giving your problem there. As for ...
F150 blower stays on5/1/2007James Melnyk
  Q: My '98 F150 the blower will keep running if not turned off when you shut the truck off and remove ...
  A: Wow this is a weird one but I think I would start by testing the ignition switch. There is a ...
power window operation5/1/2007James Melnyk
  Q: i have a 1997 mustang gt, the last couple of days both driver and passenger power windows have been ...
  A: Is it a convertible or a coupe?? With wiring your always out there in the dark without the vehicle ...
1984 Lincoln town car - kicking and bucking5/1/2007Jason Short
  Q: I have a 1984 Lincoln Town Car with a 302. Sometimes when driving at a steady speed the car will ...
  A: Brian, I would next give it a tune up and change the fuel filter. The fuel filter will probably be ...
Low side a/c pressure connection4/30/2007James Melnyk
  Q: My a/c stopped blowing cold. Only blows cool. I figure it needs r-134a recharge. Where is low side ...
  A: Well this makes more sense. If the chirping happens when the ac is trying to engage look at the ...
Tilt steering wheel & turn signal4/30/2007James Melnyk
  Q: The pick-up in question is a 91' F-150. The only problem I can find is that the turn signal won't ...
  A: My personal opinions aside on this I recommend pricing out a used column from an autowrecker or a ...
1999 Ford Contour4/30/2007James Melnyk
  Q: How do you remove the armrest on the drivers seat?
  A: Well to start with fold the armrest down. Then use a tie rod splitter and insert that between the ...
Low side a/c pressure connection4/30/2007James Melnyk
  Q: My a/c stopped blowing cold. Only blows cool. I figure it needs r-134a recharge. Where is low side ...
  A: I would really like to assist you, but to start off with I need to know what kind of vehicle we are ...
2004 f-150 fuel filter4/16/2007Jason Short
  Q: My f-150 just started acting as if it were running out of gas if you hit passing gear. I was told ...
  A: Robert, the fuel filter is going to be on the inside of the frame, just behind the driver's side ...
no spark4/15/2007Jason Short
  Q: i need to know how to pinpoint a spark problem on a 1989 ford,i know you only go to 1985 but was ...
  A: Jim, first you need to check to make sure your rotor is turning inside the distributor. Next, you ...
brake problems4/13/2007Jason Short
  Q: I have been hearing a dragging /rubbing noise since replacing my rear brake shoes, and some times ...
  A: Martin, you might want to look at your brake adjuster inside the drum. It is possible that you have ...
93 v6 auto Ford Explorer4/12/2007Jason Short
  Q: When I crank my truck i hear the fuel pump prime and it cranks an runs fine. But sometimes it seems ...
  A: Matt, after reading your last statements I would be more inclined to believe that the idle change is ...
driveshaft4/11/2007Jason Short
  Q: i have a 75 f100 390 c6 and a 79 f100 that the motor and trans is going in to here is my ...
  A: Thomas, what I would do is go to a salvage yard and find the drive shaft that I needed. It ...
Gas guage4/9/2007Jason Short
  Q: I have a 85 ford f150 302 w/ dual tanks. The front tank works, guage and pump. When i switch over ...
  A: William, I have thought about this one for a while and I have asked people that have more experience ...
Ford F100 rear axle4/8/2007Jason Short
  Q: Last week my the rear axle on my truck seperated from the rear drive and the whole wheel came off ...
  A: John, this is a very involved type of question. First you will need to open the cover and make sure ...
1984 F1504/6/2007Jason Short
  Q: How do I change the front drive shaft on a standard transmission 300 engine
  A: Thomas, are you asking me how to disconnect the driveshaft from the transmission? If you are, then ...
1983 4x4 front hub removal4/5/2007Jason Short
  Q: I am trying to replace my front rotors and have caliper, outer hub lock cap and the "C" clip on the ...
  A: Johnathan, the snap ring is tough to get out. I will start by using some lubricant to clean out the ...
Axle and hub swap for '83 Ford Bronco4/5/2007Jason Short
  Q: Jason, I hope that you will be able to answer this question for me..I own a project 1983 Ford ...
  A: Jeff, to answer your question, yes, those parts will interchange. Now, it sounds to me like your ...
Dana 44 knuckles4/4/2007Jason Short
  Q: I have a 83 Ford Ranger with a dana 44 from a '77 bronco (disc brakes). I recently changed the ...
  A: Jason, this is a difficult question. I would call 303-688-6882. This is a company that I have used ...
93 v6 auto Ford Explorer4/3/2007Jason Short
  Q: When I crank my truck i hear the fuel pump prime and it cranks an runs fine. But sometimes it seems ...
  A: Matt, if you can hear that the fuel pump is not priming at times, then you may have a bad fuel pump. ...
Towing Capacity3/31/2007Jason Short
  Q: I hope you can answer a question for me. I own a 1976 Ford F-150 heavy half ton long box 2WD pick-up ...
  A: Tom, there are a few things that you have to consider when you are towing a large "thing." First ...
ford f150 20003/31/2007Jason Short
  Q: truck engine light is on, truck is wanting to go when iam sitting still and have the brake on when ...
  A: Tracy, do you mean that the truck is idling very high? If your check engine light is on, you can ...

Page:  Previous  |  8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17  |  Next      All

Ford

All Answers


Answers by Expert:


Ask Experts

Volunteer


James Melnyk

Top Expert on this page

Expertise

I am able to answer questions regarding newer and current Ford related questions. Please ask all questions with the year and model of vehicle please. Makes it easier to assit you. I am away on weekends but will reply when i return on monday. Sorry for the inconvenience.

Experience

I am a certified diesel tech at a busy Ford dealership. I specialize in the ford 6.0 litre diesel as well as the new 6.4 litre. Full time employed and willing to assist where i can

Education/Credentials
Licenced automotive service technician, Ford factory trained diesel tech,

©2012 About.com, a part of The New York Times Company. All rights reserved.