AboutDennis W Expertise I am a retired Ford master tech specializing in electrical, climate control, emissions, driveability, chassis, brakes, and any light repairs. Currently employed by an independent shop that appreciates my knowledge and abilities.
Cannot answer transmission or parts questions, these are not areas of my expertise.
Experience 32 years of auto repair, diagnosis, and emissions testing, in service staions, independent garages, and 20 years with Ford dealers.
Organizations National Street Rod Association (NSRA)
International Automotive Technicians Network (IATN)
www.blueovaltechs.com
IAMAW (retired)
National Street Rod Association
<
Education/Credentials Riverside City College Automotive technology program
Ford Master Tech Certified Engine and Chassis Master (Over 500 hours)
ASE Certified in 7 categories
6 years training in Union 76 Pro-tech program
Awards and Honors 4-time Technician of the Year at Almaden Lincoln Mercury
Ford Master Tech
Union 76 Pro-tech Master tech
How can I replace he driver side window's motor for Ford Expedition 99.
I tested the signal and found the motor is bad.
I already took the door panel out.
Can you help.
Thanks.
Salah
Answer Here is the procedure, the "dimples" are on the metal surface of the inside of the door. With the waterscreen off you can locate the motor to help you tell where the dimples are. Drill holes then use a socket to remove window motor bolts.
Front Door Window Regulator Motor
Removal and Installation
Raise the front door window glass to the full up position.
Remove the front door trim panel.
Remove the door speaker.
Position the watershield aside.
CAUTION: Make sure the electrical connector is positioned aside before drilling.
To access the power window motor bolts, use a 19 mm (3/4-in) hole saw with a 8 mm (1/4-in) pilot to drill three holes at the existing drill dimples on the door.
Disconnect the front door window regulator electrical connector.
Remove the bolts and the front door window regulator motor.
To install, reverse the removal procedure.
Cycle the window glass to make sure the gears engage
