	AllExperts > Experts
	Search

About Gerry Magill
Expertise
I am a Software Architect employed by a large multi-national communications company providing VoIP and tradtional TDM communications to Enterprise customers.

Experience

Past/Present clients
IBM, SBS, Siemens, KPMG, Bank Berlin, Commerzbank

You are here: Experts > Internet/Online > Internet Conferencing > IP Telephony > VOIP

IP Telephony - VOIP

Expert: Gerry Magill - 4/10/2008

Question
Dear Mr. Gerry Magill;

Hope you are fine and doing well,I am doing call termination by Quintum/Tenor Ax series device.
I want to route different dial plans on a specific FXO port.for example at the moment I am routing 001313 on port no. 1 tilll 7 and I want to route 001818 on port no. 8.
Is it possible to assist me how I can do it.
I am looking forward to hearing from you as soon as possible.

Best regards
Amir

Answer
You must first create a channel group and associate it to a routing group.

To see how to create a channel group, i.e. group1 for circuits 1-7 and then a group2 for circuit 8, see the user guid at:

http://ae.quintum.com/support/products/2G/tenor_2G/sysdoc/webhelp/quintum_tenor_...

Look under Command Reference Guide -> Telco Circuit Configuration -> Circuit/Channel Configuration -> Channel Group (cg) Prompt Level

Then, associate that channel group with a routing group. If you do not have a routing group configured yet, see how thats done here:

Command Reference Guide -> Telco Circuit Configuration -> Trunk Routing Configuration -> TrunkCircuitRoutingGroup Prompt Commands (tgrg#)

You then associate the Hop off Number (i.e. 001818) with the tcrg number.

Add to this Answer Ask a Question

About Us | Advertise on This Site | User Agreement | Privacy Policy | Help
Copyright © 2008 About, Inc. About and About.com are registered trademarks of About, Inc. The About logo is a trademark of About, Inc. All rights reserved.