About kenji Toelken Expertise I will do my best to answer questions regarding chassis electrical, suspension, car audio, parts fabrication, engine and drive train. I don't claim to know everything there is to know about mechanics, hopefully through this experience I can learn some stuff from all of you as well.
Experience I have been involved in auto mechanics and restoration for 30 years. I have owned and restored about 50 cars ranging from Peugeot to Hillman. I have recently built 2 CJ-5's from the ground up, fabricated parts for both and currently own a Cherokee XJ in progress.
Jeep Repair - installing a stabilizer bar repair kit
Expert: kenji Toelken - 5/17/2008
Question This job seems very simole but i would like to make sure i am doing it doing it right.How exactly do i install this part on my 94 jeep cherokee 2wd, this bart is for the front of the car
Answer Hi Jermaine,
If you're replacing the rubber bushings where the stabilizer bar is mounted to the frame then remove the mounting bolts on each side, pull the brackets off of the stabilizer bar, replace the bushings and bolt back on. If you are replacing the link bushings on each end of the stabilizer bar remove then remove the nut on each side, note the position of bushings and washers on the link before you remove them. You'll install the new ones in the same order, replace the nut.
