| Subject | Date Asked | Expert |
|
| Braking noise | 2/22/2008 | Kevin |
Q: After I come to a complete stop, I am feeling a grinding through the brake pedal. Car is in neutral ...
A: if the jeep is not in motion then it would be nothing to do with the brake system or any moving ...
|
| Jeep Grand Che. Ltd. 3 issues please help | 2/20/2008 | Kevin |
Q: I am having 3 issues the first is the left turn signal only works when it wants mainly when it is ...
A: the no heat yes is blend air door U will need to remove the dash to fix buy a manual for ...
|
| R&R 1998 Jeep Wrangler 4.0 exhaust header | 2/20/2008 | Kevin |
Q: I need to weld a broken pipe intersecting the collector. What gaskets do I need and what do I have ...
A: exhaust gasket and possible the flange to where it goes to the rest of the pipe. INSTALLATION ...
|
| 1996 jeep cherokee classic a/c | 2/18/2008 | Kevin |
Q: My a/c works fine, the only thing is that it only comes out from the top and bottom vents not the ...
A: check to make sure u can move the actuators then see if its a vac issue or a servo issue. ...
|
| taillight | 2/18/2008 | Kevin |
Q: how do i get to the electrical clip to replace housing unit for the tail lamp? ANSWER: need to know ...
A: REMOVAL Disconnect and isolate the negative battery cable. From the underside of the vehicle, ...
|
| 2002 Jeep Liberty 2.4L Fuel Injector Repairs | 2/18/2008 | Kevin |
Q: Kevin, I'm trying to remove the fuel rail to a clogged injector and leaking o-ring. To get at the ...
A: REMOVAL 2.4L WARNING: THE FUEL SYSTEM IS UNDER CONSTANT PRESSURE EVEN WITH ENGINE OFF. BEFORE ...
|
| 1996 jeep cherokee | 2/17/2008 | Kevin |
Q: How do I locate the motor blower. I understand that it is under the dashboard passenger side but how ...
A: BLOWER MOTOR 2.5L ENGINE Disconnect the battery negative cable. Disconnect the blower motor wiring ...
|
| Driver's side door check replacement | 2/15/2008 | Kevin |
Q: My 2002 Grand Cherokee door won't hold in the open position. I assume I need a new door check arm. ...
A: door trim panel REMOVAL Remove trim plug from mirror flag bezel. Remove screws attaching trim panel ...
|
| 94 wrangler steering problems | 2/12/2008 | Kevin |
Q: I recently asked you about helping me identify and fix a wandering front end. You only left a ...
A: and I sent that response because infact it is outside of my experience and I only have manuals ...
|
| headlights | 2/12/2008 | Kevin |
Q: Both of my low beam headlights stopped working. I have checked the fuses, everything is good. Is ...
A: the junction block is on the driver aide under a black small panel u will haft to remove.Best way ...
|
| AC leaking | 2/11/2008 | Kevin |
Q: I have a 1997 Jeep Grand Cherokee It is in Haiti being used in our mission. The AC leaks water onto ...
A: NO: 24-06-96 SUBJECT: A/C Evaporator Drain Blockage DATE: June 28, 1996 SYMPTOM/CONDITION: Debris ...
|
| Blower motor replacement | 2/11/2008 | Kevin |
Q: I need to replace the blower motor on my 1996 Jeep cherokee country, 200,000 miles
A: BLOWER MOTOR REMOVAL Disconnect and isolate the battery negative cable. Disconnect the blower motor ...
|
| 96 Jeep Grand Cherokee | 2/9/2008 | Kevin |
Q: How do you remove ignition lock cylinder to replace?
A: IGNITION SWITCH AND KEY CYLINDER The ignition switch is located on the steering column. The ...
|
| 99 Grand Cherokee Limited | 2/9/2008 | Kevin |
Q: I have 2 questions, the 1st is simple. I was wondering if the tow package has a brake controller ...
A: brake controllers are sold separate due to the fact that there are so many different kinds to the ...
|
| Fuel filling issues | 2/9/2008 | Kevin |
Q: 2002 Jeep Liberty Limited, 115,000 miles. When I go to fill my wife's Liberty with gas the gas pump ...
A: Difficulty Refueling Vehicle Shortly After A Cold Engine Start OVERVIEW: This bulletin involves the ...
|
| REMOVE IGNITION CYLINDER | 2/8/2008 | Kevin |
Q: How do I remove the ignition cylinder for a 2000 jeep grand cherokee laredo experiencing problems ...
A: first of all the IGN cly is mechanical not electrical so it will have no bearing on anything ...
|
| 2002 Jeep Grand Cherokee problem | 2/6/2008 | Kevin |
Q: I have several issues that have cropped up with my car. First, looks like the blower motor module ...
A: the first part is a blower motor resistor and wire where it has burnt up the second is blend air ...
|
| 1997 TJ fuel tank removal | 2/5/2008 | Kevin |
Q: I need to remove my fuel tank to change the fuel pump module. What is the procedure? Also, is there ...
A: FUEL TANK WARNING: THE FUEL SYSTEM IS UNDER CONSTANT FUEL PRESSURE EVEN WITH THE ENGINE OFF. THIS ...
|
| 2002 jeep liberty door panel removal | 2/4/2008 | Kevin |
Q: How do you remove the back door panels of a 2002 jeep liberty? I have Taken out the screws and ...
A: REMOVAL Remove the inside handle screw plug and remove the screw. (A REAR TRIM PANEL) Remove the ...
|
| Jeep headlight repair | 2/4/2008 | Kevin |
Q: I have a used 1999 Jeep cherokee and the headlights do not work. I think that both the bulbs are ...
A: there is no such thing as a wire location diagram only where a connector is. If u want to know ...
|
| Jeep Grand Cherokee 2000 radiator removal | 2/3/2008 | Kevin |
Q: Can you tell me if the radiator can be removed separate from the AC condenser or does it have to be ...
A: RADIATOR REMOVAL WARNING: DO NOT REMOVE THE CYLINDER BLOCK DRAIN PLUGS OR LOOSEN THE RADIATOR ...
|
| 02 Jeep Cherokee fuel filter | 2/3/2008 | Kevin |
Q: where is it? and how do you change it?
A: REMOVAL The combination Fuel Filter/Fuel Pressure Regulator is remotely mounted to the vehicle body, ...
|
| replacment of camshaft sensor on jeep | 2/3/2008 | Kevin |
Q: i have a '03 jeep liberty renegade 4x4. i need to replace the camshaft position sensor, but i am ...
A: 3.7L The Camshaft Position Sensor (CMP) on the 3.7L V-6 engine is bolted to the front/top of the ...
|
| 2003 Jeep Grand Cherokee | 2/2/2008 | Kevin |
Q: How do I remove the back driver's side door panel on a 2003 Jeep Grand Cherokee?
A: REMOVAL Remove screws attaching trim panel to door (REAR DOOR TRIM PANEL). Using a trim stick ...
|
| 2000 Grand Cherokee front driveshaft removal | 2/2/2008 | Kevin |
Q: How do you remove the front driveshaft on a 2000 GC? I removed the 6 bolts at both companion ...
A: FRONT PROPELLER SHAFT NOTE: Different length propeller shafts are used for different drivetrain ...
|
| Changing Brakes | 2/2/2008 | Kevin |
Q: I was wondering if you could walk me through the DETAILED steps I need to do to change the brake ...
A: FRONT DISC BRAKE SHOES REMOVAL Raise and support vehicle. Remove wheel and tire assembly. Remove ...
|
| Leak Detection Pump | 1/30/2008 | Kevin |
Q: I'm pulling code P1495 on my '01 Jeep Cherokee Sport which means the solenoid in the LDP is bad. My ...
A: REMOVAL The LDP is located in the right-rear side of engine compartment (EVAP Canister Purge ...
|
| door panel removal, 2003 Grand Cherokee | 1/28/2008 | Kevin |
Q: How do I remove the door panel on a 2003 Jeep Grand Cherokee Laredo, front passenger door?
A: REMOVAL Remove trim plug from mirror flag bezel. Remove three screws attaching trim panel to door ...
|
| Fan removal from 01 Wrangler 4.0L | 1/26/2008 | Kevin |
Q: I am trying to change the water pump on my Jeep and need to remove the fan in order to get to the ...
A: 4.0L EngineThe thermal viscous fan drive/fan blade assembly is attached (threaded) to water pump hub ...
|
| NO HEAT | 1/26/2008 | Kevin |
Q: Kevin, I have come to the conclusion that Jeep has know about this problem/defect for some time. The ...
A: the heat treater is not a fix its a hack u will loose the dual air control and only one side will ...
|
| 2003 Jeep Liberty/ 3.7 l | 1/26/2008 | Kevin |
Q: I have a P1494 code on the obd. I need to find the Leak Dectection Pump pressure switch, does anyone ...
A: REMOVAL The Leak Detection Pump (LDP) is attached (bolted) to the front of the fuel tank (LDP ...
|
| 2000 jeep cherokee windows | 1/26/2008 | Kevin |
Q: I can only operate all three non drivers power windows from the drivers door. The separate swiches ...
A: FRONT DOOR TRIM PANEL REMOVAL Roll window down. Remove window crank, if equipped Window Crank - ...
|
| electronic key | 1/26/2008 | Kevin |
Q: I have a 04 jeep grand Cherokee laredo.i was just wondering if there was any way to disable the ...
A: u can not disable or remove the skim key system with out paying like 1000 bucks U will need to ...
|
| Jeep ignition switch removal | 1/25/2008 | Kevin |
Q: I want to replace the key switch on a '97 wrangler with manual tranny. I can't find the release pin ...
A: GNITION SWITCH AND KEY CYLINDER The ignition key must be in the key cylinder for cylinder removal. ...
|
| 02 Grand Cherokee camshaft sychronizer timing | 1/25/2008 | Kevin |
Q: My old camshaft synchronizer seized because the bearing went bad. I pulled out the old one. I ...
A: REMOVAL - 4.0L The Camshaft Position Sensor (CMP) on the 4.0L 6–cylinder engine is bolted to the top ...
|
| 2003 jeep grand cherokee | 1/23/2008 | Kevin |
Q: how do get to the headlamp to change the bulb. I am not a rocket scientists.
A: REMOVAL Remove the jack screw attaching the top of headlamp to the headlamp mounting module ...
|
| 04 jeep cherokee heater/ cruise | 1/22/2008 | Kevin |
Q: i bought a 04 jeep Cherokee Laredo a month ago. it has two problems that i am looking for a way ...
A: both issues are related one fix and U are on your way. open the hood and on the driver side look ...
|
| 2002 Jeep Liberty radiator replacement | 1/22/2008 | Kevin |
Q: I wondered how hard it is to replace the radiator in my liberty. I have a small crack at the inlet / ...
A: REMOVAL WARNING: DO NOT REMOVE THE CYLINDER BLOCK DRAIN PLUGS OR LOOSEN THE RADIATOR DRAINCOCK WITH ...
|
| radio removal | 1/21/2008 | Kevin |
Q: I have a 2002 wrangler and would like to know how to remove the trim panel to swap out the stock ...
A: Disconnect and isolate the battery negative cable. Using a trim stick or another suitable wide ...
|
| Jeep Liberty Fuel Filter | 1/20/2008 | Kevin |
Q: How do I change the fuel filter on my 2002 Jeep Liberty? I tried starting it this morning and it ...
A: REMOVAL The main fuel filter is attached to the front of fuel tank (FUEL DELIVERY COMPONENTS). Three ...
|
