AboutMike Wells Expertise PLEASE READ BEFORE ASKING A QUESTION!!! I CAN ONLY ANSWER QUESTIONS ABOUT HARLEYS !!! I DONT KNOW ANYTHING ABOUT OTHER MODELS!!! I have a Harley only shop with 30 years experience located in Ohio. We specialize in complete and total repair, restoration, hi-performance, and custom bike building. I can work on Flat Heads to Twin Cams. Please, dont ask how much somthing is going to cost to fix. Labor prices differ all over te country as well as shop to shop!
Experience Engine rebuilding (can be shipped),
Trans rebuilding (can be shipped),
Restoration,
Custom bike building
1. A few days ago the speedo stopped working. I have a Clymer manual but can't find anything on speedo checking or replacing.
2. The clutch was recently set during a service, however, it used to be very short and now the gears engage right at the end of the cluth. The problem is that the bike moves forward when stationary in 1st gear, struggles to get into and out of third. Is this just a clutch adjustment issue or a gearbox issue?
Thanks for your time and I'm sure I speak on behave of everyone when I say thanks for your help!
J
Answer On your clutch, its not releasing all the way when you pull it in. It needs to be readjusted.
As to the speedo. Either the speedo is bad, the cable or the drive unit. Jack the bike up and disconnect the speedo cable from the speedo. Spin the front tire and you should be able to see the cable turning. If not then remove the cable from the drive unit and check it for a broken end. If its not broken the you have to remove the front tire and remove the drive unit. Its probably bad
Good luck and happy riding
Mike
