Nanotechnology/Grapheme

Advertisement


Question
graphene1
graphene1  
Good day.

When not use laser, so I ask otherwise:

In Figure graphene1.jpg are two dimensional graphene sheet, length 2 m, width 1 m.
After a long side of each plate are applied 4 tabs. with a height of 5 nm, a length of 2 m long and 2 cm G3 G4 G5.G6 with graphene or other suitable material.
It is possible to combine solid projections G3 G5 and G4 G6.for example glued.
To form the structure of graphene and between 10 nm gap?

If it is not possible to suggest how one can create geometry: two conductive or dielectric plates and the gap between 1-10 nm.

Thank you very much.

Answer
Hi Marian,

Once you get two sheets of graphene, there is no way you will be able to stop these two surfaces to attach to each other.  The graphene sheets are very flexible.  If you can fill the gap with an amorphous flat material you can stop the sheets from sticking, but I guess you need an air gap?
Jan

Nanotechnology

All Answers


Answers by Expert:


Ask Experts

Volunteer


Jan

Expertise

General questions on NanoTechnology and Materials Science. Specifically in Electron Microscopy

Experience

Worked with Electron Microscopes for 25 years

Organizations
Microscopy Society of America, SAE, TMS.

Education/Credentials
PhD Materials Science

©2016 About.com. All rights reserved.