You are here:

Oldsmobile/Buick Repair/1995 Olds Silhouette Turning Lever

Advertisement


Question
The turning lever just came off, how do I fix it?

Answer
HI CARL, WELL IT MORE THEN LIKELY BROKE OFF AND DID NOT JUST FALL OFF. BUT IF YOU THINK IT JUST FELL OUT. GET A FLASHLIGHT AND LOOK REAL CLOSE AT THE SWITCH HOUSING TO MAKE SURE NOTHING IS BROKEN OR SPLIT IF ALL OK PUSH IT BACK INTO THE HOLDER AND TURN IT CLOCKWISE TILL IT SNAPS OR CLICKS BACK IN.. BUT IF IT BROKE YOU WILL  NEED TO REMOVE THE BROKEN PIECE IN THE SIGNAL MOUNT AND GET YOURSELF A NEW STALK AT YOUR GM STORE AND INSTALL IT AS I SAID ABOVE..GOOD  LUCK TO YOU,,,TOM

Oldsmobile/Buick Repair

All Answers


Ask Experts

Volunteer


TOM SHEETS

Expertise

Can answer all questions pertaining to mechanics of GM cars from 1965 to present. I will answer questions from 6:00 am to 10 pm est.. I will not take diesel or paint questions. If this olds and buick section is maxed out you can get to me in the chevrolet section...

Experience

I have 30 plus years experience in servicing these cars. I can answer questions on carburetor, fuel injection,ignition systems, suspension, brakes and abs, cooling systems,a/c and heater,manual transmissions, rear differential and electrical system,charing system and battery. I am a Master ASE certified mechanic in all 8 categories: - Brakes - Heating and Air Conditioning - Automatic transmission - Clutches and Transaxle - Engine performance - Engine repair - Electrical - Steering and suspension I am certified for NYS inspection and clean air insp.

Organizations
ASE

Education/Credentials
I am a Master ASE certified mechanic in all 8 categories (see above) I am an Air Conditioning/Freon recycling specialist with ASE. I have at least 4 years of technical training and many hours of continuing education.

Past/Present Clients
many customers in our busy shop for the past 30 plus years

©2016 About.com. All rights reserved.