About speedball1 Expertise About me: My Plumbing Expertise: I retired from plumbing after a lifetime in the trade. all phases from service and upkeep to construction, both residential and commercial. I am qualified to do anything in plumbing from fixing a leaky faucet to drafting a set of plans for a commercial shopping center and supervising the construction. My last five years were spent as a trouble shooter for a large plumbing company. I took on all my companys complaints. I have been a expert on the plumbing page at Askme.com. In a field of 200 experts my rating was number one. You may also find me at Answerway.com and AskMe Help Desk.com. This is fun for me and if I can help anybody out that`s iceing on the cake. Degrees & Certifications: As for degrees, I don`t have any. Just a Journeymans ticket, but hey! How about fifty years experience?
Experience Life Experience? Hmmmmmmm! Ran away at 15 and joined a carnival, Navy at 17 Merchant marine at 19 I've had a hellava life.
Question Hi Speedball:
I have been buying and rehabbing rundown properties for about a jear now. I currently am working on a house where the toilet flushes very slowly or incompletely. What is a simple way to address this issue. Someone suggested pouring bleach mixed with hot water down the toilet bowl. I thought of using a product like Draino. I don't know how this would work since the Draino ingredients would not be working on anything until you flush the toilet and then they would just pass through the system. Any advice would be appreciated.
Regards,
Jeff Pierson
Answer Hi Jeff, I have one that most repair plumbers miss. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH!!) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps and thank you for rating my reply. Tom
