Printers/Zebra ZT410 Label Printer
i am hoping you guys can help me solve this problem or lead me in the right direction. my friend's job recently bought this printer since they ship alot. and their IT guy is currently away some where for a couple months. so i offered myself to help out (which i now really regret). they wanted to set it up. so i installed drivers. followed through the steps, calibrated the media and when it stops right at the tear/pre perforated line. The problem(s). when it prints labels (EPL) it stops after each print for like 2 seconds then prints an other, when its done printing it does not stop at the tear line but when its done printing the label, so i would press feed so make it go to the tear line since its calibrated there but instead it skips one whole label then goes to the tear line of the blank label. so thats my problem i searched all over the web and on zebras website but i found nothing. if you guys can please help. Zebra ZT410 (Direct Thermal 4x6 Labels UPS)
disconnect parallel, usb and ethernet cables...
do automatic calibration
print test page
if calibrated... plug it up and try printing...
if issue continues then you need to do some manual calibration...