Expert: Mehdi Saharkhiz Date: 5/5/2006 Subject: moving pages from one project to another
Question Thanks for the prompt response, but let me rephrase my problem. This doesn't have to do with Master Pages. My file names are "Master Catalog" and "Aux. Lamps". I have 2 layouts in different projects. Aux Lamps has a 47 page layout. I need all 47 pages to be moved into my layout inside project entitled "Master Catalog". And the following problems occur below.
-------------------------
Followup To
Question -
I am doing a catalog in Quark 6. I have two project files: a Master Catalog project file and a Aux. Lamps project file with products and descriptions. All my layouts have a 1/4" bleed on all sides(if that's relevant).
1) I made thumbnails of both layouts, highlighted all the pages in Aux. Lamps and attempted to drag them into my layout for Master Catalog. The response is "the pages are too small.."
2)Then I tried it the opposite way: drag my Master Cat. layout into the Aux. Lamp layout and same response "too small.." . Also tried an individual page - same response.
3) Then I checked the layout properties for height and width and both layouts were the same. Also checked gutter width and guides and all were the same between the two.
4) Lastly, I tried decreasing the size of the layout pages on Aux Lamps and dragging. No response, but it still wouldn't let me.
5) Copy and Paste is not an option in thumbnail view. Tried that.
Any Ideas? PLEASE HELP. Julie Ledbetter
Answer -
Julie From what i Undesrtand all you need to do is open the masterpage and then pull the master page to the page you need taht is how you get the master on the pages you need
I hope i understood your Question right
Thank You
Mehdi
Answer This is a problem because of the small pasteboard that quark has there is an xt that fixes this also you can make a book and put the catalog together like that also you can make Eps and place in the quark box and finally you can copy and paste piece by piece and page by page.
these are the only ways you can do it
hope this helps
Thank You
Mehdi
