You are here:

Radiant Floor Heating/baseboard heating/during renovation moving baseboard


I'm not certain if this is your area of expertise since this is a baseboard heating question, not radiant.  My contractor may have to put up new wallboard and it goes behind my baseboard heating on one of the walls.  How is that normally handled - does one have to shut off and drain the pipes and pull off the baseboard, etc.?  Thanks

When moving fin-tube baseboard should be drained and disassembled, the wallboard finished and the baseboard installed again. This a great time to consider a new length of fin, more especially if the "fins" of the old one are fowled. This is where the heat comes from so, the cleaner the better.

If your contractor doesn't know this, call in a hot water heater (hydronics) technician to do the work, perform an annual clean and check and make sure you have proper air elimination, because bubbles are bad.

Radiant Floor Heating

All Answers

Answers by Expert:

Ask Experts


Morgan M. Audetat


Radiant panel heating design, including floors and ceilings, European wall panels and snow melting for residential and light commercial buildings..............................................................-Master of Steam and Hot Water,City of Minneapolis....................................................--- Master Plumber, State of Minnesota...........


30 years..... Charter Board Member - Radiant Panel Association, former manufacturer of condensing boilers, former national distributor of radiant floor products, son and apprentice of mechanical & plumbing contractor. Current mechanical/plumbing contractor specializing in hydronic based, integrated HVAC systems. Radiant floor heating/cooling. Snow Melting. Condensing Boilers. Indirect water heaters. System design, consulting and technical training world-wide. Licensed contractor, designer, installer and consultant.

B.S. University WI 1981 CONTINUING EDUCATION: Viessmann Condensing boiler and Solar water heating certification 2010, N.D.S.U. Lead Worker RRP certification 2010, Knight condensing boiler certification 2009, Wrightsoft Manual J CAD certification 2009, RPA Designer & Installer Certification 2008, Nate Hydronic/Forced Air Certification 2008, Uponor/Wirsbo advanced design school certification 2007, Buderus Wall-hung certification 2007, Power Limited License (low voltage controls) 40 CE credits 2005, Basic Hydronic Certification IPEX & Northern Alberta Institute of Technology 1998, Charter Board Member - Radiant Panel Association 1994, Residential Off-Electric to Hydronic Conversion Heating School Canadian Hydronics Council 1994, B&G Little Red School House 1993, Rood Utilities (now Auburn Technical Institute) Oil Burner School 1993 ,Tekmar Controls residential and commercial 1993, Division Manager and Advanced Hydronic Seminar Instructor for the first Exclusively Hydronic Radiant Floor Distributor in the USA 1990, Hydronic Radiant Heating Association Workshop participant with Richard c. Bourne, PE spring 1988, Master Plumbing, Hydronic, Solar Course Red Rocks Community College 1987.

Awards and Honors
2009 System Showcase Award - Radiant Panel Association

©2016 All rights reserved.