AllExperts > Experts 
Search      

Small Engines (Lawn Mowers, etc.)

Volunteer
Answers to thousands of questions
 Home · More Questions · Answer Library  · Encyclopedia ·
More Small Engines (Lawn Mowers, etc.) Answers
Question Library

Ask a question about Small Engines (Lawn Mowers, etc.)
Volunteer
Experts of the Month
Expert Login

Awards

About Us
Tell friends
Link to Us
Disclaimer

 
 
 
 
About John C. Bridgers Sr.
Expertise
Small Engine Service Center Co-Owner - ATVs, Mowers, Trimmers, Snow throwers, and Many Other Small Engine Operated Equipment. I can answer questions pertaining to Most Lawn and Garden Equipment, e.g. riders, tillers, trimmers, cement mixers, chainsaws, etc. I have been repairing small engines for 34 years. Briggs & Stratton, Tecumseh, Kohler, Lawn Boy, Stihl, Poulan, Mac, and Honda; to name a few.

Experience

Past/Present clients
I have worked on small air/water cooled engines for 34 Years. I performed warranty work for Lowes of Wilson and other retailers in the area. I Own a Yard Maintenance and Certified Small Engine Repair Service Center.
 
   

You are here:  Experts > Home/Garden > Home Appliances > Small Engines (Lawn Mowers, etc.) > 20hp mercury

Topic: Small Engines (Lawn Mowers, etc.)



Expert: John C. Bridgers Sr.
Date: 7/24/2008
Subject: 20hp mercury

Question
i have a '76 mercury outboard and i snapped the recoil cord today. would you happen to have a diagram on how to fix i and put it back together? thankyou

Answer
Hello Adam:

The Following is a Recoil Starter Repair Instruction File. Any Input/Suggestions are Appreciated. Remove the Starter Housing/Engine Cover. Remove the Old Rope. Now Turn the Pulley in the Same Direction that the Pulley would Turn if the Rope was Turning it. Once the Pulley will Turn No More, then Reverse Direction 1 or 2 Turns and Thread the New Rope Through the Hole in the Center of the Pulley and Out the Hole in the Blower Housing. Pull the Rope Through Until it is Tight Against the Pulley. Now Tie a Slip Knot in the Rope to Hold the Pulley in Place While the Handle is Attached to the Rope. Once the Handle is Attached, Release the Slip Knot and the Rope Should Retract Into the Housing. Reassemble the Blower Housing Onto the Engine. On Some Models you May have to Install the Rope Before you Lock the Pulley in Place. If So, there is a U in the Pulley that the Rope is Held in While Turning the Pulley to Tighten the Spring. If you Hit a Snag or this Does Not Correct the Problem,  I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Thanks.

Good Luck

Respectfully

John

PS: I am Allowed to Answer 10 Questions a Day. If you See I am Maxxed Out, then Try Submitting your Question at or Just After 8pm EST (US). My New Day Starts then. Thanks.

Respectfully

John

Add to this Answer    Ask a Question



  Rate this Answer
   Was this answer helpful?
Not at allDefinitely              
   12345  

     
About Us | Advertise on This Site | User Agreement | Privacy Policy | Help
Copyright  © 2008 About, Inc. About and About.com are registered trademarks of About, Inc. The About logo is a trademark of About, Inc. All rights reserved.