AboutEric A. Jones Expertise Lawnmower Repair . Certified Master Service Technician from B&S. Have 13 years experience on B&S, Lawn Chief, Weed Eater, Echo, Peerless, Wheel Horse, Snapper, Atlas, MTD, McCulloch, Homelite and many other numerous brands. Specialize in electrical repair.
Experience Born and raised in the midwest. Started tinkering with engines when I was about 14 on my Suzuki RM-80. I began lawn mower repair at a small hardware store. I knew absolutely nothing. I read lots of repair manuals and met an older fellow who taught me many lessons. I continued working on small engines through high school and paid my way through college working on mowers at the same hardware store. Decided to get away from the midwest and mower repair so I joined the Air Force. I repaired air traffic control electronic equipment and ended up in Hawaii where I got a part time job at Small Engine Clinic. I gained a lot of experience from the Small Engine Clinic and had a blast repairing small engines. I then took the Briggs and Stratton Master Service Technician test and earned my MST. I then traveled to Wisconsin where I attended the factory update training seminar and received formal training. I received a scholarship from the Air Force and am currently pursuing another degree.
Question QUESTION: Hi Eric,
I have a Toro Personal Pace mower model 20031. I'm getting a grinding noise in the rear wheel assembly and the self propel seems to be slipping. I replaced the pinion gear on one side that was worn down but it is still not working correctly. I think the gear inside the transmission assembly may be worn as well. How do I replace that.
Thanks, Paul
ANSWER: Checked the parts lists...no internal trasmission parts are available...you have to replace the assembly, part number 106-3956.
Have you checked both rear wheels and pinion gears? Have not had any issues with the gear boxes but it is bound to happen.
If both wheels and pinion are alright, then I would crack open the transmission and see if there is any damage before buying a new one.
Eric
---------- FOLLOW-UP ----------
QUESTION: Hi Eric,
Thanks for your response. I did open up the transmission and I can see that there is some fairly significant wear on one side of the gear bevel (part# 104-8671) that is on the axle. Can I just replace this part? And if so, what is the best way to do it. Thanks in advance for your help.
Paul
Answer Googled your part number and came across this link:
Remove the axle assembly, clean the short axle shaft with plumbers sandpaper, remove the retaining pin and slide off the bevel gear on the short side of the axle. Install new bevel gear in reverse order.
