You are here:

Small Engines (Lawn Mowers, etc.)/Tecumseh Small Engine Carburetor repair

Advertisement


BagODonuts wrote at 2009-08-05 20:19:52
What a great answer. I have the same exact problem after trying to start a Tecumsah after a few years of hibernation. I was getting no fuel and took the bowl off. It was full of bad gas (varnish). After pulling on the  float to hard, the needle valve came out with the spring. I thought I had installed it correctly, but after reading this post, i will check it again.

Thanks for your answer!


phil mcmanis wrote at 2010-04-20 17:28:40
Matt, i too have a 6hp Horse with the same engine and would like the diagram of the carb.. if  you get this from Allen.. could you forward it to me??  mine has been a good tiller .. even has a rebuild done in 90...


old wrench wrote at 2014-10-07 18:12:11
if you don't have a puller just back off the crank nut until the top of nut is even with threads then put a pry bar under the fly wheel and pull up and at the same time with a good hammer give the nut a healthy crack and the fly will pop off! same idea as removing old style steering wheels.


Small Engines (Lawn Mowers, etc.)

All Answers


Answers by Expert:


Ask Experts

Volunteer


Allen Kirkland

Expertise

Mechanical, electrical, custom design & fabrication.

Experience


Past/Present clients
michelin tire corp, uniroyal corp, BFG corporation, current hobby is building one-off custom yard type go-karts, made a track for my girls, who are quickly becoming better drivers than I

©2016 About.com. All rights reserved.