AboutEric A. Jones Expertise Lawnmower Repair . Certified Master Service Technician from B&S. Have 13 years experience on B&S, Lawn Chief, Weed Eater, Echo, Peerless, Wheel Horse, Snapper, Atlas, MTD, McCulloch, Homelite and many other numerous brands. Specialize in electrical repair.
Experience Born and raised in the midwest. Started tinkering with engines when I was about 14 on my Suzuki RM-80. I began lawn mower repair at a small hardware store. I knew absolutely nothing. I read lots of repair manuals and met an older fellow who taught me many lessons. I continued working on small engines through high school and paid my way through college working on mowers at the same hardware store. Decided to get away from the midwest and mower repair so I joined the Air Force. I repaired air traffic control electronic equipment and ended up in Hawaii where I got a part time job at Small Engine Clinic. I gained a lot of experience from the Small Engine Clinic and had a blast repairing small engines. I then took the Briggs and Stratton Master Service Technician test and earned my MST. I then traveled to Wisconsin where I attended the factory update training seminar and received formal training. I received a scholarship from the Air Force and am currently pursuing another degree.
Question -------------------------
Followup To
Question -
my john deere is a s1400 with a 30cc engine. how do i replace the pull rope?
Answer -
Is the starter cord on the back of the trimmer or in the front?
Let me know.
Eric
eric, it is in the front. when i got to the pull rope section one of the tabs on the plate was underneath where the rope is. when i tried to remove the top plate the spring unwound. was that tab supposed to be on the top with the other two.
Answer Yes the tab should be on top. As for the spring installition, start by inserting the outside spring hook into the housing retaining slot. Just work the spring round and round until it's in the housing. With the spring in place, install the starter pulley with the rope wound on the pulley into the starter housing.
Leave about 6 to 8 inches of rope hanging out of the pulley. There should be a slot on the outside lip of the pulley where the rope can fit into.
With everything in place, grab the end of the rope and turn the pulley 5 to 6 times. This should wind the spring and the rope should feel like it wants to retract onto the pulley. Holding the tensioned pulley, feed the loose end of the string through the string hole and then tie the handle. If the rope does not fully retract then you may need a few more turns to tighten it.
Let me know if this makes any sense...it's easy to do but difficult to describe.
Do you have to remove the clutch to access the starter pulley? JD has too many trimmer models to remember. If fact, JD does not make any of their own trimmers. Over the years they have been produced by McCulloch, Homelite, and Tanaka just to name a few.
