About Michael Expertise Ex-Tool & Die Maker. For the last 30 years I have performed maintenance on a large estate, including mechanical repairs of cars, trucks, tractors, ATV's, carts & trailers, chainsaws, mowers, snowblowers, machinery, hand tools. I do blade & tool sharpening, modifications and adaptations requiring designing and fabrication of accessories or parts made of metal, wood or plastic. Indoor skills include repair of appliances, furniture, electrical wiring, plumbing and structure.
Question Mower wont start and I think its because i hit something. Could it be the key and if so would it be the one at the flywheel or the blade? Its a Murray 6hp self propelled 3 in 1 rear bagger.
Answer Hi Steve,
Yes, if it quit right after striking an object, I could almost guarantee that the flywheel key is sheared. The timing would then be off. The flywheel is located
under the recoil/cooling shroud. Its' bore is tapered and mates with the tapered crankshaft. The keyway in the flywheel and shaft keeps it from spinning on the shaft. A nut secures it. Use an impact wrench on the nut or a strap on the flywheel. Don't put force on the cooling fins or they will break. The recommended way to remove a flywheel is to use a puller. An alternative, is to tap on the crankshaft top, with a brass hammer or use a punch
tip on an air hammer. The flywheel will need to be held up and supported or upward pressure applied with 2 large prybars. (A 2 person job.) Care is needed so the flywheel
doesn't crack or bend. Also be careful to not mushroom over the crankshaft top. Replace the key. Install the flywheel after cleaning the tapers and re-tighten the nut to 65 ft/lbs.
There is also the possibility of a bent or twisted crankshaft depending on the severity of the impact but usually the key just shears.
