AllExperts > TV/VCR/Stereo Troubleshooting 
Search      
TV/VCR/Stereo Troubleshooting
Volunteer
Answers to thousands of questions
 Home · More TV/VCR/Stereo Troubleshooting Questions · Answer Library  · Encyclopedia ·
More TV/VCR/Stereo Troubleshooting Answers
Question Library

Ask a question about TV/VCR/Stereo Troubleshooting
Volunteer
Experts of the Month
Expert Login

Awards

About Us
Tell friends
Link to Us
Disclaimer

 
 
 
 
About cleggsan
Expertise
Consumer Electronics of all kinds. Audio, esoteric audio systems and components, video, tv. Digital equipment for consumer use. Ham radio and automotive electronics. Note: I give advice on tv repair based on general consumer electronics engineering experience but I am not engaged in actual repair of sets. MAKE SURE YOU GIVE THE MAKE AND MODEL NUMBER AND AGE OF THE SET.

Experience
Electrical Engineering; recording, broadcasting, design, international standards, tv and radio theory and practice.

Organizations
FELLOW of AES (Audio Engineering Society)
Senior Life Member of IEEE (Institute of Electronic and Electrical Engineers)
International Consulting Organization


Publications
IEEE Spectrum
Various Consumer Electronic publications

Education/Credentials
BSEE
MSCS
MBA

Awards and Honors
Famous Engineer for Digital Audio


 
   

You are here:  Experts > Home/Garden > Home Appliances > TV/VCR/Stereo Troubleshooting > Panasonic plasma TV proplems

TV/VCR/Stereo Troubleshooting - Panasonic plasma TV proplems


Expert: cleggsan - 7/3/2009

Question
dear sir,
kindly give me yr valuable advice on my panasonic plasma TH50PY800H proplems as follow:
The half sreen goes black after 15 minutes of watching and other half having bad picture going up and down. i turned it off and after about 3 hours i turned it on then no proplem found, however it last about 15 mins then the screen goes black again. it continued happening like that again and again.

i am attaching the image for your clear understand my proplems.

your immidiate reply would be highly appriciated,

thanks and best regards

Tran Thuy

Answer
Thanks for good image to help me determine what is going on.

It looks to me as though there is a power supply deficiency wherein a voltage regulator or bridge rectifier is not getting high enough voltage to the main display board and associated electronics.  It may require you to have the P service tech come to your place for examinations.  This set runs quite hot inside and based on your comments the power supply ailment may be temperature/heat related.  

Have you done a hard reset?  This is done by disconnecting the power cord for at least one full hour before powering it back up.  This will sometimes cure a corrupted software code, but it won't do much good where there is a physical or electronic failure.  Worth giving it a try, nonetheless.

Hope this helps.
C  

Add to this Answer   Ask a Question


 
User Agreement | Privacy Policy | Kids' Privacy Policy | Help
Copyright  © 2008 About, Inc. AllExperts, AllExperts.com, and About.com are registered trademarks of About, Inc. All rights reserved.