TV/VCR/Stereo Troubleshooting/RESET QUASAR MODEL VV2008


Patty Jackson-Lemp wrote at 2013-04-19 09:21:16
For the Quasar TV/VCR model VV2008, if you push and hold the play button and the FFwrd buttons at the same time, hold for about 5 seconds or longer,  it will cycle the set off. When you turn it back on, the auto channel programming mode will be showing on screen. If you don't have the remote, simply push the channel up button, and it will program the channels.

TV/VCR/Stereo Troubleshooting

All Answers

Answers by Expert:

Ask Experts




Consumer Electronics of all kinds. Audio, esoteric audio systems and components, video, tv. Digital equipment for consumer use. Ham radio and automotive electronics. Note: I give advice on tv repair based on general consumer electronics engineering experience but I am not engaged in actual repair of sets. MAKE SURE YOU GIVE THE MAKE AND MODEL NUMBER AND AGE OF THE SET. BE SURE TO CHECK YOUR EMAIL FOR THE RETURN ANSWER DURING THE NEXT 24 HOURS AS I TRY TO REPLY TO ALL QUESTIONS WITHIN THE SAME DAY IF NOT THE SAME HOUR.


Electrical Engineering; recording, broadcasting, design, international standards, tv and radio theory and practice.

FELLOW of AES (Audio Engineering Society)
Senior Life Member of IEEE (Institute of Electronic and Electrical Engineers)
International Consulting Organization

IEEE Spectrum
Various Consumer Electronic publications


Awards and Honors
Famous Engineer for Digital Audio

©2017 All rights reserved.