AllExperts > Experts 
Search      

Volkswagen Repair

Volunteer
Answers to thousands of questions
 Home · More Questions · Answer Library  · Encyclopedia ·
More Volkswagen Repair Answers
Question Library

Ask a question about Volkswagen Repair
Volunteer
Experts of the Month
Expert Login

Awards

About Us
Tell friends
Link to Us
Disclaimer

 
 
 
 
About Rocky Racoon
Expertise
Most questions that relate to interior, and exterior equipment removal, and re-installation. Also, mechanical repairs of the engine, and the axles, and the brakes.

Experience
35 years auto repair experience. 3 years specifically Volkswagen. 10 years ago, graduated from general technical college. Deans list graduate. One of several hundred, out of several thousand to compete, and win recognition within Volkswagen for knowledge, and excellence.
 
   

You are here:  Experts > Home/Garden > Auto Repair > Volkswagen Repair > 2000 New Beetle Cooling Problem

Topic: Volkswagen Repair



Expert: Rocky Racoon
Date: 6/3/2007
Subject: 2000 New Beetle Cooling Problem

Question
Hello,

I replaced the thermostat on the 2000 New Beetle 2.0 SOHC engine and read where the water pump impellers were possibly plastic. While having the thermostat "gooseneck" off, I was able to actually see the impellers of the water pump and they rotated as they should while bumping the engine. If the impeller is rotating I presume it should be pumping. This leads me to believe I may have blocked lines or a severely corroded radiator. Any suggestions? The coolant was filled with rust and I am now planning on a flush. Also, have there been reports of bad electric motors on the fans for the radiator?

Answer
Bud..Hi there, did you do the thermostat replacement yourself?  When you refilled the engine cooling system, did you follow the factory guidelines on evacuating the entire cooling system to a pressure of 2 bar, and then refill with fresh, low phosphate, pink coolant from your Volkswagen dealer?  Since the gooseneck was off it should have been possible to feel the impeller with 2 fingers.  I always feel them to see if they are still secure on the drive shaft.  Cooling system problems are created, more often than not, by not getting the system filled with the right stuff, and not starting with a fully evacuated system.

Add to this Answer    Ask a Question



  Rate this Answer
   Was this answer helpful?
Not at allDefinitely              
   12345  

     
About Us | Advertise on This Site | User Agreement | Privacy Policy | Help
Copyright  © 2008 About, Inc. About and About.com are registered trademarks of About, Inc. The About logo is a trademark of About, Inc. All rights reserved.