AllExperts > Experts 
Search      

Volkswagen Repair

Volunteer
Answers to thousands of questions
 Home · More Questions · Answer Library  · Encyclopedia ·
More Volkswagen Repair Answers
Question Library

Ask a question about Volkswagen Repair
Volunteer
Experts of the Month
Expert Login

Awards

About Us
Tell friends
Link to Us
Disclaimer

 
 
 
 
About Rocky Racoon
Expertise
Most questions that relate to interior, and exterior equipment removal, and re-installation. Also, mechanical repairs of the engine, and the axles, and the brakes.

Experience
35 years auto repair experience. 3 years specifically Volkswagen. 10 years ago, graduated from general technical college. Deans list graduate. One of several hundred, out of several thousand to compete, and win recognition within Volkswagen for knowledge, and excellence.
 
   

You are here:  Experts > Home/Garden > Auto Repair > Volkswagen Repair > 2000 VW Jetta GL 2.0 Fuel Air Metering Code

Topic: Volkswagen Repair



Expert: Rocky Racoon
Date: 10/12/2007
Subject: 2000 VW Jetta GL 2.0 Fuel Air Metering Code

Question
My wife 2000 Jetta has a problem of being very sluggish and even cutting out when put into a forward gear and trying to accelerate. However it does not do this in reverse.Code reader gave these codes P1128 Fuel Air Metering, P0172 System too Rich, P0301 Cylinder 1 Misfire. I have already changed plugs and wires, and I put a new fuel pump and filter in about 7 months ago. What could be causing this problem?

Answer
Hi Steve;
This 2.0 litre engine has an engine code of "AEG."  That means this car has an actual throttle cable to the throttle body, and depends on vacuum to meter fuel pressure.  There is a small vacuum hose that is normally covered with braided cloth material to do something...I don't like it, it gets real brittle, and breaks.  Take off the plastic cover over the engine.  Under it you will see a small hose at the left hand side(as you are looking at it).  It is probably broken.  Replace it, and see if the off idle throttle response improves.  That's the cheap fix.  There's another, also very likely scenario...the MAF sensor is probably bad, as well.  It's the thing with the wire connector on the back side of the filter housing.
Good luck, Steve.

Add to this Answer    Ask a Question



  Rate this Answer
   Was this answer helpful?
Not at allDefinitely              
   12345  

     
About Us | Advertise on This Site | User Agreement | Privacy Policy | Help
Copyright  © 2008 About, Inc. About and About.com are registered trademarks of About, Inc. The About logo is a trademark of About, Inc. All rights reserved.